Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 116)

46 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
SAN discovery overview
3
16. Enter the authorization password in the Auth Password field.
• If you selected Configure for 256-Port_Director_Name, go to step 19.
• If you did not select Configure for 256-Port_Director_Name, continue with step 17.
17. Select the privacy protocol in the Priv Protocol field.
18. Enter the privacy password in the Priv Password field.
19. Click OK on the Add Fabric Discovery dialog box.
If the seed switch is not partitioned, continue with step 20 .
If the seed switch is partitioned, the Undiscovered Seed Switches dialog box displays.
a. Select the Select check box for each undiscovered seed switch to discover their fabrics.
b. Click OK on the Undiscovered Seed Switches dialog box.
20. Click Close on the Discover Fabrics dialog box.
Reverting to a default SNMP community string
To revert to the default SNMP parameters, complete the following steps.
1. Select Discover > Fabrics.
The Discover Fabrics dialog box displays.
2. Select an IP address from the Discovered Fabrics table.
3. Click Edit.
The Add Fabric Discovery dialog box displays.
4. Select the Automatic option.
5. Click OK on the Add Fabric Discovery dialog box.
6. Click Close on the Discover Fabrics dialog box.
Rediscovering a fabric
To refresh discovery of a fabric, complete the following steps.
1. Select Discover > Fabrics.
The Discover Fabrics dialog box displays.
2. Select a fabric in the Discovered Fabrics table.
3. Click Rediscover.
The application triggers all fabric and switch level collectors. The status of the refresh displays
in the Master Log as an application event for the fabric as well as each switch in the fabric. For
example, “Fabric information collection was successful for the fabric - Fabric_Name”.
4. Click Close on the Discover Fabrics dialog box.