Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 986
914
Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Layer 3 access control list policy
22
b. Enter a port number or select a port application name from the Start list.
If you selected range from the Operator list, enter the port number or name of the lower
numbered port in the range. Click the ellipsis button to launch the Service dialog box to
see a list of services and service groups. For more information about services and service
groups, refer to
c. Enter a port number or select a port application name from the End list.
If you selected range from the Operator list, enter the port number or name of the higher
numbered port in the range.
7. (TCP and UDP protocols only) To filter packets by the destination port, complete the following
steps.
Only available when you select TCP or UDP from the Protocol list.
a. Select one of the following options:
•
none — Select to not use the destination port numbers to filter packets.
•
equals — Select to use the TCP or UDP port name or number specified in the Start
field.
•
not equal — Select to use all TCP or UDP port numbers except the port name or
number specified in the Start field.
•
greater than — Select to use all TCP or UDP port numbers greater than the port
number or the numeric equivalent of the port name specified in the Start field.
•
less than — Select to use all TCP or UDP port numbers that are less than the port
number or the numeric equivalent of the port name specified in the Start field.
•
range — Select to use all TCP or UDP port numbers between the TCP or UDP port name
or number specified in the Start field and the End field.
b. Enter a port number or select a port application name from the Start list.
If you selected range from the Operator list, enter the port number or name of the lower
numbered port in the range. Click the ellipsis button to launch the Service dialog box to
see a list of services and service groups. For more information about services and service
groups, refer to
c. Enter a port number or select a port application name from the End list.
If you selected range from the Operator list, enter the port number or name of the higher
numbered port in the range.
8. (IPv4 ACL only - ICMP protocol only) To filter packets by the ICMP message type, complete the
following steps.
a. Choose one of the following message types:T
•
any-icmp-type
•
echo
•
echo-reply
•
information request
•
mask-reply
•
mask-request
•
parameter-problem
•
redirect
•
source-quench
•
time-exceeded
•
timestamp-reply
•
timestamp-request
•
unreachable