Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 2097)

Brocade Network Advisor SAN + IP User Manual 2025
53-1003155-01
MAPS groups
50
FIGURE 891 Add Group dialog box
i. Enter a unique name for the group in the Name field.
The name can be up to 32 characters and can only contain alphanumeric and
underscore characters.
ii. Add objects to the group by selecting the object (port or circuit) in the Available
Ports/Circuits list and clicking the right arrow button.
The selected objects move from the Available Ports/Circuits list to the Selected
Ports/Circuits list.
iii. Remove objects from the group by selecting the object (port or circuit) in the Selected
Ports/Circuits list and clicking the left arrow button.
The selected objects move from the Selected Ports/Circuits list to the Available
Ports/Circuits list.
4. Click OK on the Add Group dialog box.
The new group displays in the Custom Groups folder of the Rules area.
5. Configure policies and rules for the group. For more information, refer to “Configuring a MAPS
policy” on page 2010.
6. Click OK on the Add Policy dialog box.
7. Click Close on the MAPS Configuration dialog box.
Editing a group
If a new object, such as host, target, or SFP transceiver is added to a fabric, you can monitor the
object using existing rules for similar objects.
The group must be the same type as the new object you want to monitor (port, circuit, or SFP).
The object is automatically monitored using the existing rules that have been set up for the group,
as long as the rules are in the active policy. You do not need to re-enable the active policy.