Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1621)

Brocade Network Advisor SAN + IP User Manual 1549
53-1003155-01
GSLB site management
39
GSLB site management
The Site Configuration dialog box allows you to configure a GSLB ServerIron ADX product with site
parameters. A GSLB site contains GSLB ServerIron ADX products that belong to that site.
Click the Site Configuration tab on the GSLB dialog box to view the GSLB sites that have been
defined for the system, and perform one of the following tasks:
• Click Add to create a new GSLB site.
• Select an existing GSLB site, and click Edit if you want to modify it.
• Select an existing GSLB site, and click Duplicate if you want to create a new site by copying an
existing site.
Adding a site configuration
1. Click Add on the Site Configuration tab on the GSLB dialog box.
The Site Configuration dialog box displays, shown in Figure 709 .
FIGURE 709 Site Configuration dialog box
2. Enter a name for the site configuration in the Name field and a site name in the Site Name
field.
3. Select the location of the site from the Site Location list.
4. Select the Distributed Health Check check box if you want to enable health checks for all
ServerIron ADX products at this site.
5. Enter the weight assigned to the ServerIron ADX product in the site in the Weight field. GSLB
traffic can be distributed among GSLB sites based on weights configured for the sites. The
weights determine the percentage of traffic each site receives in comparison with other sites,
which may or may not have weights. Weight applies to all the ServerIron ADX products in the
site.
The weight can be from 0 through 100. The default is 0. If you want to use this weight, then do
not enter IP weights in the zone configuration.