Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 182)

112 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Individual IP device discovery
3
The password can be from 1 through 16 characters long, case sensitive, and allows all
printable ASCII characters. The password display as asterisks.
6. Configure the SNMPv3 read only credentials by completing the following steps.
a. Click the SNMPv3 Read Only tab.
b. Enter the SNMPv3 user name in the User ID field.
The user name can be from 1 through 16 characters long, case sensitive, and allows all
printable ASCII characters.
c. Select one of the following protocols from the Authentication Protocol list:
• None
• HMAC_MD5
• HMAC_SHA
d. Enter the SNMPv3 authentication password in the Authentication Password field.
The password can be from 8 through 16 characters long, case sensitive, and allows all
printable ASCII characters. The password display as asterisks.
e. Select one of the following privacy protocol types from the Privacy Protocol list:
• None
• CBC-DES
• CFB_AES-128
If you select a privacy protocol, the selected protocol encrypts the SNMP request and
response packets.
f. Enter the privacy password in the Privacy Password field.
The password can be from 1 through 16 characters long, case sensitive, and allows all
printable ASCII characters. The password display as asterisks.
7. Configure the SNMPv1 and SNMPv2c read-write credentials by completing the following steps.
a. Click the SNMPv1/v2c Read/Write tab.
FIGURE 43 SNMPv1/v2c credentials
b. Enter the community string in the Community field.
The community string can be from 1 through 16 characters long, case sensitive, and
allows all printable ASCII characters. The string displays as asterisks.