Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1951)

Brocade Network Advisor SAN + IP User Manual 1879
53-1003155-01
Configuration policy manager scheduling
47
1. Select One Time from the Frequency list.
2. Select the time of day you want deployment to run from the Time (hh:mm) lists.
Where the hour value is from 1 through 12, the minute value is from 00 through 59, and the
day or night value is AM or PM.
3. Click the Date list to select a date from the calendar.
4. Click OK on the Schedule Properties dialog box.
To finish configuring the configuration policy manager, return to step 6 of “Adding a
configuration policy manager” on page 1873.
Configuring an hourly configuration policy manager schedule
To configure an hourly schedule, complete the following steps.
1. Select Hourly from the Frequency list.
2. Select the minute past the hour you want deployment to run from the Minutes past the hour
list.
Where the minute value is from 00 through 59.
3. Click OK on the Schedule Properties dialog box.
To finish configuring the configuration policy manager, return to step 6 of “Adding a
configuration policy manager” on page 1873.
Configuring a daily configuration policy manager schedule
To configure a daily deployment schedule, complete the following steps.
1. Select Daily from the Frequency list.
2. Select the time of day you want deployment to run from the Time (hh:mm) lists.
Where the hour value is from 1 through 12, the minute value is from 00 through 59, and the
day or night value is AM or PM.
3. Click OK on the Schedule Properties dialog box.
To finish configuring the configuration policy manager, return to step 6 of “Adding a
configuration policy manager” on page 1873.
Configuring a weekly configuration policy manager schedule
To configure a weekly schedule, complete the following steps.
1. Select Weekly from the Frequency list.
2. Select the time of day you want deployment to run from the Time (hh:mm) lists.
Where the hour value is from 1 through 12, the minute value is from 00 through 59, and the
day or night value is AM or PM.
3. Select the day you want deployment to run from the Day of the Week list.