Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1767)

Brocade Network Advisor SAN + IP User Manual 1695
53-1003155-01
IP sFlow configuration
43
8. If you do not chose the Prompt check box, complete the following for each field.
- Source VM — Enter the name, IP address, or MAC address of the source VMs in comma
separated value (CSV) format or click the ellipsis button to the right of the field to select
the VMs from the Select VMs dialog box.
- Destination VM — Enter the name, IP address, or MAC address of the destination VMs in
comma separated value (CSV) format or click the ellipsis button to the right of the field to
select the VMs from the Select VMs dialog box.
- Source VM Host — Enter the name or IP address of the source VM hosts in comma
separated value (CSV) format or click the ellipsis button to the right of the field to select
the VM hosts from the Select VM Hosts dialog box.
- Destination VM Host — Enter the name or IP address of the destination VM hosts in
comma separated value (CSV) format or click the ellipsis button to the right of the field to
select the VM hosts from the Select VM Hosts dialog box.
9. Select the Layer 2 tab.
FIGURE 773 Add Report Definitions dialog box, Layer 2 tab
10. Examine each listed item and decide the following:
- Do you want to enter values in the field, or be prompted to enter the value when running
the report? If you want to be prompted, select the Prompt check box.
- If you choose to list values in the field, would you rather include or exclude the listed
values? The selector next to the field may be used to include (=) or exclude (!=) the values.
- Are the values relevant to the design of your report? If not, leave the fields blank.
11. If you do not chose the Prompt check box, complete the following for each field.
- Source MAC Address — Enter the source MAC addresses in comma separated value (CSV)
format or click the ellipsis button to the right of the field to select the MAC addresses from
the Source MAC Address Selector dialog box.
- Destination MAC Addresses — Enter the destination MAC addresses in comma separated
value (CSV) format or click the ellipsis button to the right of the field to select the MAC
addresses from the Destination MAC Address Selector dialog box.
- Source VLAN Numbers — Enter the source VLAN numbers in comma separated value (CSV)
format.
- Destination VLAN Numbers — Enter the destination VLAN numbers in comma separated
value (CSV) format.
- Input Priority (QoS priorities for inbound traffic) — Enter the input priority (O - 7).
- Output Priority (QoS priorities for outbound traffic) — Enter the output priority (0 - 7).