Scheduling a pbr policy deployment – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 941
Brocade Network Advisor SAN + IP User Manual
869
53-1003155-01
Policy-based routing
21
7. Select one or more of the following to capture snapshots:
•
Select the Pre-deployment check box to capture a snapshot of the product’s configuration
prior to deployment of the security configuration.
•
Select the Post-deployment check box to capture a snapshot of the product’s configuration
after deployment of the security configuration.
If you select the Post-deployment check box, enter the amount of time (between 1 and
300 seconds) you want the application to wait before capturing the snapshot in the Delay
field.
8. Select one or more products to which you want to deploy the configuration in the Available
Targets list and click the right arrow button to move them to the Selected Targets list.
9. Click OK on the Deploy to Products - PBR dialog box.
Scheduling a PBR policy deployment
To schedule a PBR policy deployment, complete the following steps.
1. Select Schedule.
2. Select one of the following save configuration options:
•
Save to running — Select to update the running configuration; however, the deployment is
not saved to the product’s flash memory.
•
Save to running and startup — Select to update the running configuration as well as save
the deployment configuration to the product’s flash memory. Selecting this option is the
equivalent to a write memory command on the product CLI.
•
Save to running and startup then reboot — Select to update the running configuration,
save the deployment configuration to the product’s flash memory, and reboot the product.
Selecting this option is the equivalent to entering a write memory and a reload command
on the product CLI.
3. Enter a name for the deployment in the Name field.
4. Enter a description for the deployment in the Description field.
5. Click the Schedule Enable check box and click the ellipsis button to schedule deployment.
The Schedule Properties dialog box displays.
6. Choose one of the following options to configure the frequency at which deployment runs for
the schedule:
•
To configure deployment to run only once, refer to
“Configuring a one-time deployment
•
To configure hourly deployment, refer to
“Configuring an hourly deployment schedule”
•
To configure daily deployment, refer to
“Configuring a daily deployment schedule”
•
To configure weekly deployment, refer to
“Configuring a weekly deployment schedule”
•
To configure monthly deployment, refer to