Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1471)

Brocade Network Advisor SAN + IP User Manual 1399
53-1003155-01
Product configuration templates
34
5. Click the CLI Commands tab and complete the following steps.
FIGURE 628 CLI Template dialog box - CLI Commands tab
a. (Configuration templates only) Select the Evaluate CLI responses check box to validate the
CLI commands.
You can add a dash (-) to the beginning of a CLI command to ignore command validation
even when you select the Evaluate CLI responses check box.
Clear the Evaluate CLI responses check box to send all CLI commands to the device
regardless of the success or failure of the previous command.
b. Enter CLI commands in the CLI Commands field.
For a list of guidelines to use when entering CLI commands, refer to “CLI command
guidelines” on page 1405.
The Management application provides several CLI command examples (including ACL,
MPLS, Network OS-AMPP, Network OS-Access Gateway, Network OS-QOS,
MISCELLANEOUS, MCT, Network OS-THRESHOLDING, HYPEREDGE, VRF, VCS Virtual
Fabrics, Network OS-NAS, PRIVATE VLAN, Ironware OS VLAN,and Network OS VLAN). To
view the CLI command examples, navigate to the Example CLI Commands folder (refer to
“CLI Templates” on page 2221).
Add commands from the CLI templates or examples by selecting one or more commands
from the CLI Templates or Example CLI Commands folder and clicking the right arrow
button.