Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 804)

732 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Cluster mode
17
# you can pass either yes(1) or no(2) or stop the execution(3)
#
CLIConfigManager.ValueForConfirmationCLICommands=1
CLIConfigManager.ValueForConfirmationCLICommands.MinInt=1
CLIConfigManager.ValueForConfirmationCLICommands.MaxInt=3
CLIConfigManager.ValueForConfirmationCLICommands.IsDisplay=false
3. Save and close the file.
Cluster mode
A cluster is a set of wireless controllers working collectively to provide redundancy and load
sharing. You can discover wireless controllers in cluster mode.
To verify that the wireless controller is in cluster mode, check the following:
1. Check the Properties dialog box.
Right-click the wireless controller and select Properties.
The Properties dialog box displays.
• If the controller is the active controller, the Access Points tab is included.
• If the controller is the standby controller, the Access Points tab is not included.
2. Check the Detailed AP Products report (refer to “AP Products report” on page 734).
For wireless controllers in cluster mode, it should show the cluster name ( “Detailed AP
Products report” on page 735)
3. Check the Wired Products report (refer to “IP Wired Products report” on page 2068).
In the Wired Products report, click the controller in cluster mode to display the Cluster details:
• Cluster Name — The cluster name.
• Cluster Mode — The cluster mode of the AP. Options include Active and Standby.

If the controller is the active controller, the cluster mode is Active.

If the controller is the standby controller, the cluster mode is Standby.
• Cluster members — The IP address of the controllers in cluster mode.
4. Check the port group ( “Port Groups” on page 150) connected to the AP.
The port group should only show the port information for the active controller in clustering
mode.
VLAN management
You can use VLAN Manager to view existing Virtual Local Area Network (VLAN) configurations on
the wireless products and the network.
Instructions for configuring policy monitors are detailed in Chapter 36, “VLAN Management” and
include information about the following:
“Displaying a list of VLANs” on page 1442
“Select a product in the Available Products pane and click the right arrow button to move it to the
Selected Products pane and enable VCS Virtual Fabric mode.”
on page 1447