Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 656)

584 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Microsoft System Center Operations Manager (SCOM) plug-in
12
1. Select Tools > Plug-in for SCOM.
The Plug-in for SCOM dialog box displays.
2. Click Add.
The Add SCOM Server dialog box displays.
3. Enter an IP address or fully qualified domain name for the SCOM host in the Host field.
The Management application accepts IP addresses in IPv4 and IPv6 formats. The IPv4 format
is valid when the operating system has IPv4 mode only or dual stack mode. The IPv6 format is
valid when the operating system has IPv6 mode only or dual stack mode.
4. Enter the domain name in the Domain field.
5. Enter your user ID and password.
6. Click OK.
7. Click Close.
Editing a SCOM server
To edit the SCOM server, complete the following steps.
1. Select Tools > Plug-in for SCOM.
The Plug-in for SCOM dialog box displays.
2. Select the server you want to edit and click Edit.
The Edit SCOM Server dialog box displays. The Host field is not editable in the Edit SCOM
Server dialog box.
3. Edit the domain name in the Domain field.
4. Enter your user ID and password.
5. Click OK.
6. Click Close.
Removing a SCOM server
To configure the SCOM plug-in, complete the following steps.
1. Select Tools > Plug-in for SCOM.
The Plug-in for SCOM dialog box displays.
2. Select the SCOM server you want to delete in the SCOM Servers table.
3. Click Remove.
4. Click OK on the confirmation message.
5. Click Close.