Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 2012)

1940 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Event action definitions
48
NOTE
Auto Acknowledge is enabled only when Take actions for the selected events when they occur
is selected in the Policy step of the Event Actions Wizard. If you edit an Event Action that has
Auto Acknowledge selected and change this option in the Policy step to Time-bound or
Frequency-bound, you will be required to confirm your choice.
3. Select the Enable Troubleshooting check box to suppress events based on user-entered
criteria. You can suppress events for up to 168 hours (7 days). This action is applicable to IP
devices only.
4. Select the Alert by E-mail check box if you want an e-mail message to be sent to an
administrator if the policy criteria have been met.
5. Select the Run Policy Monitor check box to execute a policy monitor as an action based on a
selected event, and then select the target for the policy monitor from the list. Target options
include Event Sender and Specified in Config.
6. Select the Launch a Script check box if you want to execute to an external script file when the
matching criteria have been met, and then enter the script in the accompanying field.
7. Select the Broadcast to Client check box, and click Configure to broadcast a message to all the
clients when the matching criteria have been met.
NOTE
The remaining parameters are not available if a non-Fabric OS, IronWare OS, or Network OS
product is selected as an event sender.
The Broadcast Message dialog box displays.
a. Select a severity level from the list.
b. Type a message in the Message Content field.
c. Click OK.
8. The Mark as Special Events check box is unselected by default. Leave it this way if you want
the event action to be added to the Special Event Handling event action category. Refer to
“Special events handling” for more complete information.
9. Click the Collect support save check box to enable SupportSave on the event. The check box is
unselected by default.
10. Select the Deploy CLI Configuration check box and click Configure if you want to deploy a
configuration from CLI Configuration Manager to products if the policy criteria have been met.
You can only deploy a CLI configuration for IP products.
NOTE
If the CLI configuration you chose from CLI Configuration Manager contains a non-IronWare OS
or Network OS product as a target, the configuration will not be deployed to the non-IronWare
OS or Network OS product.
11. You can either select an existing CLI configuration or create a new one and select that
configuration. After selecting a CLI configuration, the name of the CLI configuration is
displayed in the Selected Configuration field.