Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 270)

200 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Software Configuration
5
Server impact
• Configuration wizard (does not display all IP addresses)
• Trap and Syslog auto registration
• Report content (Ipconfiguration element does not display all server IP addresses)
• Network OS configuration backup through FTP
• Trace dump through FTP
Client impact
• Options dialog box (does not display all IP addresses)
• Firmware import and download dialog box
• Firmware import for Fabric OS and Network OS products
• FTP button in Technical Support Repository dialog box
• Technical supportSave of Fabric OS, Network OS, and Host products through FTP
To configure the IP address used by the server for client-server communications, complete the
following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select Client/Server IP in the Category list to set the IP address.
The Client/Server IP pane displays ( Figure 78 ).
FIGURE 78 Options dialog box (Client/Server IP option)
3. Choose one of the following options in the Server IP Configuration list.
• Select All. Go to step 4 .
• Select a specific IP address. Continue with step 5 .
• Select localhost. Continue with step 5 .
When Server IP Configuration is set to All, you can select any available IP address as the
Return Address. If you select a specific IP address, the Return Address list shows the same IP
address and you cannot change it.