Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1776)

1704 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
IP sFlow configuration
43
FIGURE 783 Add Schedule dialog box
4. Enter a name for the schedule in the Name field.
5. Use the Report Definition selector to select the report definition you want to schedule.
NOTE
Report definitions that included a prompt are not listed.
6. Use the Format selector to choose either HTML or CSV format.
7. Use the Frequency selector to choose to run the data collector on a Yearly, Monthly, Weekly,
Daily, Hourly, or One Time basis. Appropriate options are displayed allowing you set a start time
and duration for data collection.
- If you select Yearly, or One Time, the Time(hh:mm) and Date selectors display.
- If you select Monthly, the Time(hh:mm) and Day of the Month selectors display.
- If you select Weekly, the Time(hh:mm) and Day of the Week selectors display.
- If you select Daily, the Time(hh:mm) selector displays.
8. If you want to send the report to an e-mail recipient, check the E-mail check box.
9. If you checked the E-mail check box, select recipients under Available Recipients and use the
right arrow to move them to Selected Recipients. Use the Other Recipients field to add
recipients that are not listed under Available Recipients.
10. Enter an e-mail address for replies in the Reply To field. This is mandatory.
11. Enter text for the subject line in the Subject Line field.