Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1567)

Brocade Network Advisor SAN + IP User Manual 1495
53-1003155-01
VLL manager
37
3. Click Next.
The VLL Configuration wizard Port Configuration dialog box displays ( Figure 682 ).
FIGURE 682 VLL Configuration wizard Port Configuration dialog box
The last discovered port settings for VLLs are displayed in the Discovered Endpoint Settings
table. You can make changes to the settings in the Configured Endpoint Settings table.
4. To configure port settings for a port that has not been configured, select a port from the
interfaces tree and click Add to add a row to the Configured Endpoint Settings table.
NOTE
You must configure two endpoints.
Provide the following information:
a. From the Tag Mode list, select one of the following:
• Tagged: If the endpoint is a tagged port, the device transmits the packet with the
specified VLAN ID and forwards it out the specified interface.
• Untagged: If the endpoint is an untagged port, the device removes any VLAN ID before
transmitting it out the specified interface.
b. For tagged ports only, enter a VLAN ID for the service provider end point tag in the Outer
VLAN ID field.
Packets with this VLAN ID are transmitted out the specified interface. If you configure dual
tagged (inner and outer VLAN ID) endpoints, make sure you meet the following
requirements:
• Requires an Ethernet router, Core router, or Backbone router with firmware version 5.0
and later.
• You can only define a specific Inner VLAN ID/Outer VLAN ID combination once for all
VLL or VPLS instances.