Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1395)

Brocade Network Advisor SAN + IP User Manual 1323
53-1003155-01
Port groups
30
Creating a port group
NOTE
At least one switch must be reachable to create a port group.
To create a port group, complete the following steps.
1. Select Configure > Port Groups.
The Port Groups dialog box displays, as shown in Figure 583 on page 1323.
FIGURE 583 Port Groups dialog box
2. Click New.
3. Enter a name for the port group in the Name field.
4. Enter a description for the port group in the Description field.
5. Select one or more ports to add to the group in the Group Type - FC Ports list.
A port group must have at least one port in the Membership List. All ports must be from
switches in the same fabric.
6. Click the right arrow button.
The selected ports display in the Membership List.
7. Click Update.
The new port group displays in the Port Groups list.
8. Click OK to close the Port Groups dialog box.
Viewing port groups
To view port groups, complete the following steps.