Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 141)

Brocade Network Advisor SAN + IP User Manual 71
53-1003155-01
Configuring IP profile discovery
3
FIGURE 17 Discover Setup - IP dialog box
2. Click the Global Settings tab.
a. To set SNMP credentials, refer to “IP SNMP credentials” on page 72.
b. To configure default user names and passwords, refer to “Default IP user credentials” on
page 78.
c. To configure global setting preferences, refer to “Defining global setting preferences” on
page 86.
3. Click the Profiles tab.
a. To create a discovery profile, refer to “IP discovery profiles” on page 89.
b. To include and exclude product types, refer to “IP Object identifier filters” on page 84.
c. To include and exclude devices and enable ping sweep, refer to “Configuring address
ranges” on page 92.
d. To configure profile preferences, refer to “Configuring advanced discovery profile
preferences” on page 104.
4. Click Start to start discovery. To run profile discovery, refer to “Starting discovery manually” on
page 106.
5. Click Close to close the Discover Setup - IP dialog box.
6. Click Yes on the confirmation message.