Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 776)

704 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Port Auto Disable
14
• LIP (Loop Initialization Primitive Sequence)
To configure the PAD event triggers, complete the following steps.
1. Select Monitor > Port Auto Disable.
The Port Auto Disable dialog box displays.
2. Select the fabric on which you want to configure the PAD event triggers from the Fabric list.
3. Select All Ports from the Show list to filter the port list:
4. Select one or more ports or devices on which you want to configure the PAD event triggers.
5. Click Edit.
The Edit Configuration dialog box displays.
6. Select one or more of the following event triggers:
• Loss of Sync
• Loss of Signal
• OLS (Offline Primitive Sequence)
• NOS (Not Operational Primitive Sequence)
• LIP (Loop Initialization Primitive Sequence)
7. Click OK on the Edit Configuration dialog box.
8. Click OK on the Port Auto Disable dialog box.
Enabling Port Auto Disable on individual ports
NOTE
Port Auto Disable requires devices running Fabric OS 6.3 or later.
To enable PAD on individual ports, complete the following steps.
1. Select Monitor > Port Auto Disable.
The Port Auto Disable dialog box displays.
2. Select the fabric on which you want to configure PAD from the Fabric list.
3. Choose one of the following options from the Show list to filter the port list:
• All Ports (default) — Displays all ports in the fabric.
• Disabled PAD — Displays only ports where PAD is disabled.
4. Select one or more ports on which you want to enable PAD.
Press CTRL and click to select multiple ports.
5. To configure specific events to trigger PAD (device must be running Fabric OS 7.0 or later), refer
to “Configuring Port Auto Disable event triggers” on page 703.
6. Click OK on the Port Auto Disable dialog box.