Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 999)

Brocade Network Advisor SAN + IP User Manual 927
53-1003155-01
Layer 3 access control list policy
22
Creating a service
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 899
• “Editing an extended L3 ACL configuration” on page 901
• “Copying an extended L3 ACL configuration” on page 902
• “Creating an extended L3 ACL configuration” on page 899
• “Editing an IPv6 L3 ACL configuration” on page 906
• “Copying an IPv6 L3 ACL configuration” on page 907
To create a service, complete the following steps.
1. Click the Services tab.
2. Click Add.
The Add Service dialog box displays.
FIGURE 359 Add Service dialog box
3. Enter a name for the service in the Name field.
4. Select one of the following protocol options:
• TCP
• UDP
5. Enter a port number in the Port field.
6. Click OK on the Add Service dialog box.
7. Click Close on the Service dialog box.
To finish configuring the advanced settings for the ACL, refer to “Configuring L3 ACL advanced
settings” on page 912.