Editing an extended l3 acl configuration – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 973
Brocade Network Advisor SAN + IP User Manual
901
53-1003155-01
Layer 3 access control list policy
22
•
To select a network, select IP Address and choose a network from the list.
To configure a network, click the ellipsis button and refer to
•
To enter a host name, select Host and enter the destination host name on which the ACL
filters traffic in the Host list and text field.
9. Enter a VLAN identifier (valid values are from 1 to 4095) from the VLAN list.
10. Select the Log Enable check box to enable logging.
11. Click Advanced Settings to configure additional settings for the ACL configuration.
NOTE
You must configure advanced settings to create an extended Layer 3 ACL.
The L3 ACL Advanced Settings dialog box displays. To configure additional settings, refer to
“Configuring L3 ACL advanced settings”
12. Click the right arrow button.
The new ACL displays in the ACL Entries list.
13. Use the Up and Down arrow buttons to rearrange the ACLs in the ACL Entries list.
14. View the advanced settings for an ACL by selected the ACL in the ACL Entries list and clicking
View.
The L3 ACL Advanced Settings dialog box displays.
15. Click Close on the L3 ACL Advanced Settings dialog box to close.
16. Click OK on the Add - L3 ACL Configuration dialog box.
The new ACL displays in the ACLs list.
17. To set the configuration type and operations, refer to
“Configuring the ACL configuration type
18. (Ethernet routers only) To set the hit statistics duration, refer to
19. To deploy the configuration, click OK on the Device_Name - L3 ACL Configuration dialog box.
The Deploy to Products - L3 ACL dialog box displays. To deploy the configuration, refer to
“Security configuration deployment”
Editing an extended L3 ACL configuration
To edit an extended L3 ACL configuration, complete the following steps.
1. Select the device and select Configure > Security > L3 ACL > Product.
The Device_Name - L3 ACL Configuration dialog box displays.
2. Select the ACL configuration you want to edit in the ACLs list and click Edit.
The Edit - L3 ACL Configuration dialog box displays.
3. To edit an existing rule, complete the following steps.