Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 504)

432 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
User-defined performance monitors
8
• To specify a color based on hue, saturation, and lightness, click the HSL tab. Specify
the hue (0 through 360 degrees), saturation (0 through 100%), lightness (0 through
100%), and transparency (0 through 100%).
• To specify a color based on values of red, green, and blue, click the RGB tab. Specify
the values for red (0 through 255), green (0 through 255), blue (0 through 255), and
alpha (0 through 255).
• To specify a color based on values of cyan, magenta, yellow, and black, click the CMYK
tab. Specify the values for cyan (0 through 255), magenta (0 through 255), yellow (0
through 255), black (0 through 255), and alpha (0 through 255).
• To reset to the default color, click Reset.
5. Click OK to save your changes.
User-defined performance monitors
You can customize performance monitors specific to your needs. You can define up to 100
performance monitors; however, you can only display up to 30 performance monitors at a time.
Monitor types
You can create the following types of monitors:
• Top N (Products, Ports, and Traffic Flows monitors) — Displays the top number of products,
ports, or traffic flows for the selected measure in a table.
• Bottom N (Products, Ports, and Traffic Flows monitors) Displays the bottom number of
products, ports, or traffic flows for the selected measure in a table.
• Distribution (Products and Ports monitors) — Displays the number (distribution) of products or
ports for each of the five percentage ranges defined for the selected measure in a bar graph
• Time Series (Products, Ports, and Traffic Flows monitors) — Displays the selected measures for
products, ports, or traffic flows in a chart.
• Top N sFlows — Displays the top sFlow for MAC, IP, VM, or VLAN based on available flow data in
a table.
• Performance graph — Displays the configured performance graph on the dashboard.