Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1568)

1496 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
VLL manager
37
• You can only define one dual tagged endpoint per port.
• You cannot define a dual tagged endpoint on a port if there is a 802.1ag configuration
defined on the port.
c. For tagged ports only, enter a VLAN ID for the customer end point in the Inner VLAN ID
field.
Packets with this VLAN ID are transmitted out the specified interface.
d. From the COS list, select a COS for the port.
This field applies only to local VLLs.
5. Click Apply.
If any of the endpoints
6. Click Next.
The VLL Configuration wizard Deploy Target Actions dialog box displays ( Figure 683 ).
FIGURE 683 VLL Configuration wizard Deploy Target Actions dialog box
Deploying target actions using the VLL Manager
1. From the Deploy Target Actions pane, under the Resultant Endpoint Actions, Endpoint Targets
column, select the device, or expand the folder for the device to display the VLAN ID (if the
Tagged is configured for the port’s tag mode) and the port on which the VLL is to be assigned.
2. The Actions column displays the action to take when the VLL is deployed to the devices. An
action is displayed for the device, the VLAN, and the port to which the VLL will be deployed.
Possible actions are:
• CREATE: Adds the configuration to the device.
• DELETE: Removes the configuration from the device.
• UPDATE: Modifies the configuration on the device if the configuration is being edited.
3. Click Next.
The VLL configuration wizard Deployment Properties dialog box displays ( Figure 684 ).