Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module User Manual
Page 114
Advertising
Configuration/Programming 8-9
1503-UM054C-EN-P – June 2013
Move the application disable jumper to the “Program” position as
noted on the printed circuit board.
Connect the RS-485 to RS-232 converter to the personal computer
using an RS-232 cable.
Open a new connection in hyper terminal and configure the
connection as shown below:
Figure 8.4 – Serial Port Configuration
With hyper terminal running power up the unit, the following
IntelliVAC Plus bootloader screen will appear:
Advertising