Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 283)

B-108 Parameters
1503-UM054C-EN-P – June 2013
Power Up with Invalid DIP Switch Configuration on IB5
[IB 5 Power-up with Invalid DIP Switch Configuration]
Parameter Number: 202,_,_,_,_.
Access rule: Get
Data Type: BOOL
Object Mapping: 0x384-5-30
Group: Diagnostics
Units: -
Minimum Value: 0 = Not Present
Maximum Value: 1 = Present
Default Value: 0
This parameter allows the user to view the status of the Power Up
with Invalid DIP Switch Configuration fault from the IB5 module. If
the bit is ‘0’ then the warning is not present. If the bit is ‘1’ then the
warning is present. See Power Up with Invalid DIP Switch
Configuration in Chapter 4 for a detailed description of this warning.
Under Voltage with Close Command Present on IB1
[IB 1 U/V with Close Command Present]
Parameter Number: 203,169,135,101,66.
Access rule: Get
Data Type: BOOL
Object Mapping: 0x384-1-31
Group: Diagnostics
Units: -
Minimum Value: 0 = Not Present
Maximum Value: 1 = Present
Default Value: 0
This parameter allows the user to view the status of the Under
Voltage with Close Command Present warning from the IB1 module.
If the bit is ‘0’ then the warning is not present. If the bit is ‘1’ then
the warning is present. See Undervoltage with a Close Command
Present in Chapter 4 for a detailed description of this warning.