Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module User Manual
Page 121
Advertising
8-16
Configuration/Programming
1503-UM054C-EN-P – June 2013
Figure 8.12 - Select IntelliVAC Plus in Control Flash
•
After selecting “OK” the serial number of the device and firmware
number to be flashed will be displayed select “Finish”
•
A progress bar will appear displaying the status of the transfer.
When the transfer is complete the unit will be restarted and the
following screen will be displayed after a diagnostic delay of
approximately 20 seconds. The firmware update is now complete.
Advertising