Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 16)

1-6 Product Description
1503-UM054C-EN-P –June 2013
circuits to reduce thermal output and decrease
sensitivity to leakage current.
Refer to IntelliVAC manual 1503-UM053_ _-EN-P for catalog
numbers for each version of IntelliVAC.
A Series C, D or Series E IntelliVAC module can
be used to replace a Series A or Series B module.
When replacing an older series of IntelliVAC with
a newer one, note that the Module and Contactor
Status outputs may function differently. Refer to
publication 1503-UM051_-EN-P and/or Chapter 5
of this document, and make any necessary changes
to the control circuit.
Specifications Mounting and Connections
The IntelliVAC control modules are mounted using two (2) screws
(see Figure 1.5). They are typically located in the low voltage
control panel of the medium voltage controller (Bulletin
1500/1900, 7700 controllers, in the case of Rockwell Automation).
IntelliVAC is interfaced to the Bulletin 1502 vacuum contactors
using a “quick” connector, located at the module, a wire harness
and “quick” connector at the contactor. Control power and other
control circuit connections are similarly achieved with “quick”
connectors.
Configuration
The IntellliVAC Plus is easily configured for a wide variety of
medium voltage motor and feeder control applications.
Configuration can be performed by two methods:
• DIP switches located on the IntelliVAC Plus and
IntelliVAC Base circuit boards
• Via DeviceNet and the units parameters page
Bulletin 1500/1900, 7700 controllers are shipped with IntelliVAC
pre-configured for the required application. Please refer to the
documents provided with the order.
Firmware
IntelliVAC and IntelliVAC Plus have firmware stored in Flash
EEPROM; therefore, this may be updated in the field (if
necessary). The IntelliVAC board firmware is updated via either
the multi-contactor board, or IntelliVAC Plus board RS-485 ports.
I M P O R T A N T I M P O R T A N T