Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 151)

9-28 DeviceLogix
1503-UM054C-EN-P – June 2013
Figure 9.18 – Dual Function Bit Behavior
In Figure 9.18, the “Stop” output tag is connected to the hardware
input “DLX input 1” and the “protection status” output tag is tied to
hardware input “DLX input 2”. The associated “stop” and
“protection status” bits are then used to control the status of one of
the relay outputs of the IntelliVAC Plus module.
List of bits which are dual function
:
-Interim 1
-Interim 2
-Interim 3
-Interim 4
-Interim 5
-Protection Status
-Speed SW FWD status
-Speed SW REV status
-Isolation SW status
-Remote Mode Status
-Local Mode status
-Normal Mode Status
-Test Mode Status
-Start
-Stop
-FWD
-REV
-JOG
Note
: None of these status bits will be set without first connecting it
to an input tag. All of the bits noted above will not be applicable to
any situation.