Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 280)

Parameters B-105
1503-UM054C-EN-P – June 2013
Power Up with Contactor Closed on IB4
[IB 4 Power-up with Contactor Closed]
Parameter Number: 196,164,_,_,_.
Access rule: Get
Data Type: BOOL
Object Mapping: 0x384-4-29
Group: Diagnostics
Units: -
Minimum Value: 0 = Not Present
Maximum Value: 1 = Present
Default Value: 0
This parameter allows the user to view the status of the Power Up
with Contactor Closed fault from the IB4 module. If the bit is ‘0’
then the warning is not present. If the bit is ‘1’ then the warning is
present. See Power Up with Contactor Close in Chapter 4 for a
detailed description of this warning.
Power Up with Contactor Closed on IB5
[IB 5 Power-up with Contactor Closed]
Parameter Number: 197,_,_,_,_.
Access rule: Get
Data Type: BOOL
Object Mapping: 0x384-5-29
Group: Diagnostics
Units: -
Minimum Value: 0 = Not Present
Maximum Value: 1 = Present
Default Value: 0
This parameter allows the user to view the status of the Power Up
with Contactor Closed fault from the IB5 module. If the bit is ‘0’
then the warning is not present. If the bit is ‘1’ then the warning is
present. See Power Up with Contactor Close in Chapter 4 for a
detailed description of this warning.