Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 220)

Parameters B-45
1503-UM054C-EN-P – June 2013
Status of the Change Of State Mask [Set to Defaults]
Parameter Number: 83,71,59,47,34.
Access rule: Get/Set
Data Type: USINT
Object Mapping: 0xB4-1-19
Group: Communication
Units: -
Minimum Value: 0 = No Operation
Maximum Value: 1 = Set DNet & DLX Defaults
Default Value: 0
This parameter allows the user to view and set the IntelliVAC Plus to
the factory default values. The parameters which are set to defaults
and their values are listed below.
Table B.12a – Status of the Change of State mask Defaults
Parameter Description Default Setting Parameter Group Parameter #
DNet MAC ID 63 DeviceNet 77
DNet Baudrate 500k DeviceNet 76
Autobaud enable Disabled DeviceNet 79
Consumed I/O assembly Default assembly DeviceNet 84
Produced I/O assembly Default assembly DeviceNet 85
Produced network bits & Status bits
COS mask
No mask DeviceNet 86
Preload DLX Program Selection
User Customized
Program
DeviceLogix 66
Control Mask Local DeviceLogix 67
IE DeviceLogix output fault action Fault value (0) DeviceLogix 72
IE DeviceLogix output idle action Idle value (0) DeviceLogix 74
Network override Disabled DeviceNet 91
Communications override Disabled DeviceNet 92
Time Zone GMT 00:00 DeviceNet 90
TDUV time source From IB DeviceNet 328
Drop out time source From IB DeviceNet 329
Altitude -1000 – 0000m DeviceNet 87
Loss communications action Hold DeviceNet 68
MC system locked Clear DeviceNet 349
IE status word Clear DeviceNet 345
MC status word Clear DeviceNet 346
IB1 status word Clear DeviceNet 335
IB2 status word Clear DeviceNet 336
IB3 status word Clear DeviceNet 337
IB4 status word Clear DeviceNet 338
IB5 status word Clear DeviceNet 339