Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 371)

E-6 DeviceNet Information
1503-UM054C-EN-P – June 2013
Common Service
Table E.12 - Service Codes
Service Code
Implementation for
Service Name
Class Instance
0E hex Yes Yes Get_Attribute_Single
10 hex No Yes Set_Attribute_Single
0x01 No Yes Get_Attribute_All
0x4B No Yes Get_Enum_String
Here is the list of parameters with detail attribute values:
Table E.13 – Parameters with Detailed Attribute Values
Idx Group Name Parameter Index in this Group
1 Control IE Hardware input
IE Hardware output
Preload DLX program index
Logic Mask
DOP fault action
DOP fault value
DOP idle action
DOP idle value
Network input
Network output
Run status
Ready Status
2 Communication Auto baud rate enable
Produce assembly number
Consumed assembly number
Reset to default
Produced size
Consumed size
Network output COS mask
IE Status COS mask
3 Configuration Network override
Communication override
Time zone
TDUV time source
Drop out time source
Communication loss action
Reset Faults
Altitude
MC system locked
4 Diagnostic IE status word
MC status word
IB1~IB65 status word