Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 379)

E-14 DeviceNet Information
1503-UM054C-EN-P – June 2013
Table E.25 - Instance Attribute (cont.)
Parameter
No.
Control Parameter
Access
Rule
Type Description NV CCV
58 TDUV base Time (from DIP)* Get USINT 0.2/0.5/1.0/2.0 N N
59 Line Undervoltage Hold Get BOOL 0=not present
1=present
N N
60 Contactor Long Drop Out Time Get BOOL 0=not present
1=present
N N
61 Coil Current trend*** Get LONG INT* 0~xx.xxx A N N
62 IB module status**** Get/Set UINT N N
63 Correct MC Termination
resistor@ Ibx Termination
resistor
Get BOOL 0=not present
1=present
N N
64 IB revision Get LONG INT* XX.XX N N
Note*
: In EDS its decimal position is 2, scaling to engineering unit,
i.e, the data 100 will be scale to 1.00 in RSNetWorx parameter page.
Note**:
These parameters keep the 3 latest events
Note***:
The current trend is for electrically held contactor only,
which provide a way for the IntelliCENTER software to display the
current trend of contactor’s close transition state, this parameter will
not be displayed in RSNetWorx’ parameter page.
Note****:
Some bits are set to clear fault/warning.
Note
: For IB1 this is correct MC termination resistor, for IB 2~5 this
is IBx termination resistor.
Table E.26 - Common Services
Service
Code
Implementation for
Service Name
Class Instance
0E hex Yes Yes Get_Attribute_Single
10 hex No Yes Set_Attribute_Single
18hex No Yes Get_Member*
Note*: Only used for get the event log member.