Adobe Premiere Pro CC v.7.xx - Manual (Page 179)

To the top
Note:
To the top
If an offline clip has its own capture settings, its box in this column has a check mark.
Change capture settings for an offline clip
You can change capture settings for an offline clip. For example, you can capture the clip at a resolution higher than it had when it first was
captured or logged.
1. Select the clip in the Project panel,
2. Choose Clip > Capture Settings > Set Capture Settings.
The Capture Settings dialog box opens.
3. See Specify capture settings.
Remove capture settings from an offline clip
1. In the Project panel, select the clip.
2. Choose Clip > Capture Settings > Clear Capture Settings.
By default, Premiere Pro captures this clip with the project capture settings.
Batch capture clips
1. Select the offline clips that you want to capture, and then choose File > Batch Capture.
2. In the Batch Capture dialog box, do any of the following:
Choose Capture With Handles and enter the number of frames for the handles if you want to capture frames beyond the In and Out
points identified for each clip in the batch.
The number of frames you enter here will be added to the number you set for handles in the Capture panel.
Choose Override Capture Settings if you want to replace the capture settings of individual clips in the batch with the project’s default
settings.
3. Verify that the deck and source videotape are set up properly for capture, and then click OK.
4. In the Insert Tape dialog box, insert the requested tape and click OK. If you are capturing from multiple tapes, be ready to insert them when
prompted.
5. If you want to stop batch capturing, click the Stop button in the Capture panel, or press the Esc key.
Troubleshooting batch capturing
182