WattMaster WM-WCC3-TGD-01B - Manual (Page 15)

TUC-2R AND FOUR RELAY EXPANSION
BOARD ..................................................... 12-67
TUC-2R THREE RELAY EXPANSION BOARD
AND DAMPER ACTUATOR ........................ 12-68
TUC-2R VELOCITY SENSOR .................... 12-69
RUNNING THE WCC3 PROGRAM ............. 12-70
WCC III - MCD LCD DISPLAY .................... 12-73
THE WCC III - MCD ................................... 12-78
USING THE MCD-MENU PROGRAM ......... 12-79
SECTION 13A: WCC III - MCD
INSTALLATION GUIDE
WCC III SYSTEM REQUIREMENTS ...........13A-1
THE WCC III – MCD BASIC OPERATING
CONDITIONS ............................................13A-2
Uninterruptable Power Supply .................................13A-2
MCD (Master Communications Device) ..................13A-2
Software Updates ....................................................13A-2
WCC III – MCD INTERNET ACCESS ..........13A-3
WALL MOUNTING OF THE WCC III – MCD 13A-4
SYSTEM SETUP ........................................13A-6
WCC III - MCD DISPLAY ............................13A-7
THE WCC III SYSTEM RS-485
COMMUNICATION WIRING ....................13A-12
WCC III - MCD Typical System Architecture ...... 13A-13A
INITIATING THE SYSTEM ......................13A-14
MCD System Files .................................................13A-14
THE WCC III – MCD .................................13A-15
Using the MCD-Menu Program .............................13A-16
BIOS SCREEN SETUP INFORMATION FOR THE
ADVANTECH SBC MODEL PCI-6881
(V1.20 & V1.21) ......................................13A-23
WCCIII – MCD LINUX BASE SYSTEM
INSTALL ................................................13A-25
SECTION 13B: WCC III - MCD2
INSTALLATION GUIDE
Main Differences Between the First Generation
WCCIII-MCD and the New WCCIII-MCD2
Computers ................................................13B-2
The WCCIII-MCD2 Basic Operating
Conditions ................................................13B-5
WCCIII-MCD2 Basic System
Requirements............. ..............................13B-5
Front End Software Requirements
(Operator Console Software)....................13B-5
Uninterruptable Power Supply ................13B-6
Basic Operating Conditions of the
MCD2 ........................................................13B-6
Software Updates ....................................13B-6
WCCIII-MCD2 Internet Access .................13B-6
RS-485 Communications Wiring ..............13B-7
WCCIII-MCD2 Mounting
Requirements ...........................................13B-8
Table of Contents