WattMaster WM-WCC3-TGD-01B - Manual (Page 291)

WCC III Technical Guide 3-177
WCC3.EXE SCREEN DESCRIPTIONS
Binary Global Delay Mode Screen
BINARY GLOBAL SCREEN
DELAY MODE
Binary Global Screen’s WCC III Logical Address is GBXXX, where GB = Global Binary and XXX = Global Binary Address
Mode: 8 Delay
Specifi es the mode used to generate the ON or OFF value of the
binary global. Because this is a choice fi eld, the following list of
available choices will be displayed at the bottom of the screen:
<Combinatorial, Compare, External, Alarm,
Alarm-by-Class, One Shot, Clock, Delay, PWM,
Lead-Lag>
Make your selection by pressing the <space bar> once for each
choice until the desired mode has been selected, and then press
<Enter> . Whenever you change modes, you must fi rst clear the
existing screen by using the <Ctrl> <Home> feature.
The Delay mode causes the binary global to be delayed turning ON
after a binary input has turned on and delayed turning OFF after
the binary input has turned off.
Example: Value is delayed 60 seconds for 5L3.
When binary input 5L3 is turned “On”, there will be a 60 second
delay before this binary global will turn on. Once the binary input
5L3 is turned off, there will a 60 second delay before this binary
global will turn off.
NOTE: If the binary input is turned on then off before the
delay time has expired to turn this binary global on, the binary
global will turn on after the programmed delay and then turn
off the programmed amount of time from the time the binary
input was turned off.
Example: Value is delayed 120 seconds for 5L3.
If the binary input (5L3) is turned on and then turned off after 45
seconds, the binary global will turn on 120 seconds after the binary
input was turned on and then the binary global will turn off after 45
seconds, which will be 120 seconds from the time the binary input
was turned off.