Binary global one shot mode screen – WattMaster WM-WCC3-TGD-01B User Manual
Page 287
WCC III Technical Guide
3-173
WCC3.EXE SCREEN DESCRIPTIONS
BINARY GLOBAL SCREEN
ONE SHOT MODE
Binary Global Screen’s WCC III Logical Address is GBXXX, where GB = Global Binary and XXX = Global Binary Address
Mode: 6 One Shot
Specifi es the mode used to generate the ON or OFF value of the
binary global. Because this is a choice fi eld, the following list of
available choices will be displayed at the bottom of the screen:
<Combinatorial, Compare, External, Alarm,
Alarm-by-Class, One Shot, Clock, Delay, PWM,
Lead-Lag>
Make your selection by pressing the
<space bar>
once for each
choice until the desired mode has been selected, and then press
<Enter>
. Whenever you change modes, you must fi rst clear the
existing screen by using the
<Ctrl> <Home>
feature.
The One Shot mode causes the binary global to generate an ON
value for a programmable amount of time based on a Binary value
changing from “Off to On”, “On to Off”, or both “Off to On” and
“On to Off.”
Value is ON for _______seconds when ________changes
from Off to On.
This is a three part statement. The fi rst part is the amount of time
this binary global will stay on when a binary value within the
system changes state, either “Off to On”, “On to Off” or both “Off
to On” and “On to Off”. This user-programmed amount of time is
in seconds.
The second part of this statement is the binary input that must
change state for this global to be on.
The third part of this statement is a choice fi eld. The following list
of available choices will be displayed at the bottom of the screen:
<from Off to On., from On to Off., .>
Make your selection by pressing the
<space bar>
once for each
choice until the desired mode has been selected, and then press
<Enter>
. Whenever you change modes, you must fi rst clear the
existing screen by using the
<Ctrl> <Home>
feature.
The “ .” selection will cause this binary global to generate an ON
value each time the programmed binary input value changes from
either “Off to On” or “On to Off”
Binary Global One Shot Mode Screen