WattMaster WM-WCC3-TGD-01B - Manual (Page 836)

Control Output Screens
Figure 18: Control Output Summary Screen
On a SAT 3F, and only on the SAT 3F, the Control Output Screen needs
to be programmed for the data patterns (i.e. the decimal point and the
units-of-measure) of the data registers – for example R1A and R1B,
R2A and R2B of TUC #1. Control output K1h corresponds to TUC #1
data register R1A (Heat/Cool demand), K1c corresponds to TUC #1
data register R1B(Airfl ow in CFM), K2h corresponds to TUC #1 data
register R2A (Discharge Air Temp), and K2c corresponds to TUC #1
data register R2B (Supply Air Temp).
32 VAV/Zone Controller Actuator Package Technical Guide
Programming a SAT 3F