WattMaster WM-WCC3-TGD-01B - Manual (Page 41)

I. INTRODUCTION
WCC III Technical Guide I-19
Accessory Boards - Global Bridge
Global Bridge Board (SS5012)
The WCC II to WCC III Global Bridge Board provides a means
for the new WCC III system to pass information to and from the
old WCC II system.
A single WCC II to WCC III Global Bridge Board can simulate
(mirror) up to 8 WCC II SAT II Controllers. A WCC II to WCC
III Global Bridge can also share Global Binary and Global Analog
information from WCC II to WCC III and current values of the
simulated (mirrored) satellites from WCC III to WCC II. But this
is a one way data fl ow for the Global data. The direction is from the
WCC II system to the WCC III system. See Section 20 for specifi c
use and application of the WCC III Global Bridge Board.
The WCC III Global Bridge Board has 3 status lights. The functions
of these lights or LEDs are listed below:
• POWER - This LED will be lit any time power is
applied to the WCC III Vout RELAY board.
• COMM - This LED will be lit when WCC III
communications are being received by the Global
Bridge Board.
• SAT II STAT - This LED will be lit when WCC II
communications are being received by the Global
Bridge Board.
Figure I-15: The Global Bridge Board