Metrohm tiamo 2.4 (process analysis) - Manual (Page 1027)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1011
Designa-
tion Description
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
.IME Initial measured value (measured value before start con-
ditions are processed) in the unit of the measured value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point on
the measuring point list
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.MEA Measured value for the last measuring point of the mea-
suring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the measur-
ing point list in °C
.LP.TIM Time in s until the last measuring point in the measuring
point list is reached
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.SLO Electrode slope of the sensor used for the command (in
mV for ISE sensors)
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
5.6.4.9.2 MEAS Conc - General/Hardware
Tab: Method ▶ MEAS Conc ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the device, the sensor and the stirrer are
defined on this tab.