Metrohm tiamo 2.4 (process analysis) - Manual (Page 53)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 General program functions
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 37
NOTE
For method variables of the next sample data line, the following rules
apply:
￭ If in a determination a method variable of the next sample data line
is used, the data type of this variable has to be identical to the one
of the current sample data line. If this is not the case, then the value
invalid will be assigned to the variable.
￭ Method variables of the next sample data line are always read out of
the sample table at the beginning of the determination.
￭ In the case of a single determination or if the current determination
is the last determination of a series, all of the method variables of
the next sample data line contain the value invalid.
2.4.3.4 Command variables
Dialog window: Formula editor ▶ Variables
The command variables are method-specific and depend on which com-
mands are used in the method. Included among the command variables
are also solution and sensor variables, which are applied automatically
from the corresponding tables in the Configuration for the instrument-
dependent commands when the determination is started and which are
assigned to the individual commands. The Variables field of the formula
editor lists all Command variables that are available for the current
method.
Syntax
'Command name.Variable identification'
Examples: 'DET U 3.SME', 'Track 6.BSY', 'Liquid Handling 4.CONC'
Command variables can be selected directly in the formula editor under
Variables
▶ Command variables in order to avoid syntax errors.
Command variables
Unless marked otherwise, all of the variables listed here in alphabetical
order are of the Number type.