5 set ipol - titration parameters, Titration parameters – Metrohm tiamo 2.4 (process analysis) User Manual
Page 769
■■■■■■■■■■■■■■■■■■■■■■
5 Method
tiamo 2.4 (for Process Analysis)
■■■■■■■■
753
Endpoint 2
NOTE
Is active only for EP1 at ≠ off.
on | off (Default value: off)
Enable/disable endpoint 2. If this is disabled all following parameters are
not visible.
EP2 at
Measured value for the second endpoint.
Titrando, 855
Input range
–2,000.0 - 2,000.0 mV
Selection
off
Default value
off
Titrino
Input range
–2,000 - 2,000
Selection
off
Default value
off
For additional parameters for Endpoint 2, see Endpoint 1.
5.6.3.4.5.5
SET Ipol - Titration parameters
Tab: Method
▶ SET Ipol ▶ Properties... ▶ Titration parameters
Command name
Name of the command.
Entry
25 characters
Parameters for the run of the titration.
Titration direction
Selection of the titration direction. If two endpoints are set, then the titra-
tion direction is already established and the following selection of titra-
tion direction is ignored.
Selection
+ | - | auto
Default value
auto
+
positive measured value alteration
-
negative measured value alteration