Metrohm tiamo 2.4 (process analysis) - Manual (Page 1409)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1393
6.5.2 Device table
6.5.2.1 Device table - Desktop
Subwindow: Configuration ▶ Devices
Contents
In the device table the following information about automatically recog-
nized or manually added devices is shown per default:
Device name
Designation of the device.
Device type
Type of device.
Device serial number
Serial number of the device.
Status
Device status. A device that is ready has the status ok shown in green, a
device that is not ready has the status not ok shown in red.
NOTE
The device status is permanently monitored and updated for USB devi-
ces only. For Metrohm devices with RS-232 connection, the current sta-
tus at the last access to the device is shown always. For balances, bar-
code readers and generic RS-232 devices, the status cannot be moni-
tored. It will be set to ok after confirmation of the connection test.
Set to work
Date on which the device was added to the device table.
Next GLP test
Date on which the next GLP test is due. If GLP monitoring is switched on
and the set date is before the current date (i.e. the GLP test has not yet
been carried out) then the date will be shown in red.
Remarks
Remarks about the device.