Metrohm tiamo 2.4 (process analysis) - Manual (Page 1571)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1555
Program version
Shows the program version of the device.
Only visible with devices that have their own firmware.
[Update]
Opens the dialog window Load new program version (see Chapter
7.17.6, page 1606).
This button is only displayed with devices that have their own firmware. It
is only active if the device has an old program version not supported by
tiamo and which can be updated by tiamo itself.
Device serial number
Shows the serial number of the device.
Set to work
Shows the date on which the device was automatically added to the
device table.
Data storage under legal control
Indicates whether the balance has its own data storage under legal con-
trol.
Only visible and editable with Sartorius balances
Selection
on | off
Default value off
Remarks
Remarks about the device.
Entry 1000 characters
Default value empty
7.9.3 Properties - Tower
Tab: Configuration ▶ Device ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Tower
On the tab Tower the tower parameters for the tower mounted on the
774 Oven Sample Processor are shown. These cannot be edited, but
must be set on the device itself via the keyboard.
Max. stroke path
Shows the lowest permitted lift position for the tower. A lift height of 0
mm corresponds to the "Home position", i.e. the lift is moved right to the
top.