Metrohm tiamo 2.4 (process analysis) - Manual (Page 1442)

6.7 Sensors subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1426 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
￭ History
Shows the last 10 calibration values.
￭ Electrode test
Information about the electrode test.
6.7.3.2 Properties - Sensor
Tab: Configuration ▶ Sensors ▶ [Edit] ▶ Properties... ▶ Sensor - 'Name'
Sensor name
Name of the sensor.
Entry 24 characters
NOTE
The name of the five nondeletable standard sensors pH electrode,
Metal electrode, ISE electrode, Temperature sensor and Con-
ductivity sensor cannot be changed.
Sensor type
Shows the type of sensor. Intelligent sensors are additionally marked with
IS.
Ion
Shows the ion to be measured and its valence. This parameter only
appears for ISE electrodes.
Order number
Order number of the sensor (read-only for intelligent sensors and the
Thermoprobe).
Entry 24 characters
Default value 'empty'
Sensor serial number
Serial number of the sensor (read-only for intelligent sensors and the Ther-
moprobe).
Entry 10 characters
Default value 'empty'
Device
For nonintelligent sensors it is possible to select the device to which the
sensor is connected. All the devices in the device table which have a mea-
suring input are shown in the selection list. The connection of a sensor to
a particular device is not checked during the run. In the case of intelligent