Metrohm tiamo 2.4 (process analysis) - Manual (Page 1316)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1300 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
￭ >0: For 100% stirrer output (Parameter 1 = 100), pulse duration in
10 ms
Example:
Parameter 1 = 100, Parameter 2 = 30: Pulse duration switched-on
300 ms, switched off 0 ms
Parameter 1 = 75, Parameter 2 = 30: Pulse duration switched-on
225 ms, switched off 75 ms
Input range -214783647 - 214783647
Default value 0
5.6.11.3 DIGITAL IN
5.6.11.3.1 DIGITAL IN - Overview
Dialog window: Method ▶ DIGITAL IN ▶ Properties... ▶ DIGITAL IN - 'Command
name'
Devices
This command can be executed with the IO controller and the Stepping
Motor Controller.
Appearance
The command has the following appearance:
Mode of operation
At the time of the command, the statuses of all of the digital inputs are
entered and saved in command variables (syntax 'Command name.Vari-
able identification').
Parameters
The parameters for the DIGITAL IN command are set on the following
two tabs:
￭ General
Parameters for instrument.
￭ Stop criteria
Parameters for the definition of the stop criteria.
Command variables
The following command variables are generated by the DIGITAL IN com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Port name.Variable identification':