Metrohm tiamo 2.4 (process analysis) - Manual (Page 1567)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1551
Stirrer 1
Stirrer type
Display of the stirrer type.
Stirrer serial number
Display of the serial number of the connected stirrer.
Remote box 1
Display of the connected remote box.
7.8.6 Properties - RS-232
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties ▶ Properties - 'Device type' -
'Device name' ▶ RS-232
COM Port
Selection of the serial interface on the PC to which the device is con-
nected.
Selection COM1 | COM2 | … | COMn
Default value COMn
COMn
First free COM port.
Baud rate
Transmission speed. Additionally, this baud rate must be set on the device
itself.
Selection 1200 | 2400 | 4800 | 9600
Default value 9600
[Connect]
Establishes a connection to the RS-232 device.
[Disconnect]
Disconnects the connection to the RS-232 device.
NOTE
These parameters are only editable for devices with status not ok
(power supply and/or RS connection interrupted).