Metrohm tiamo 2.4 (process analysis) - Manual (Page 1512)

7.1 874 Oven Sample Processor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1496 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Input range 3 - 25 mm/s
Default value 25 mm/s
7.1.4 Properties - Rack
Tab: Configuration ▶ Device ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Rack
On the tab Rack the rack-specific data of the attached rack are shown.
Rack name
Shows the name of the rack attached. If no rack is in position then "-----"
is shown.
Rack code
Shows the rack code of the rack attached. The rack code corresponds to
the arrangement of magnets on the base of the rack and is read in by the
Sample Processor in order to recognize the rack. If no rack is in position
then the display will be empty.
Number of positions
Shows the number of positions on the rack. If no rack is in position then
the display will be empty.
Shift rate
Sample rack speed of rotation for manual operation.
Input range 3 - 20 °/s
Default value 20 °/s
[Rack Data]
Opens the dialog window Rack data (see Chapter 6.12.3.1, page 1487)
or Rack data (774) (see Chapter 6.12.3.6, page 1492) in which the data
of the rack attached can be displayed and edited.
[Initialize rack]
Initializes the attached rack. This resets the rack, the lift and the robotic
arm, reads out the rack code and transfers the corresponding rack data to
the Sample Processor.
7.1.5 Properties - MSB #
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ MSB #
On the tabs MSB # the properties of the connector and the devices con-
nected to are displayed.