Metrohm tiamo 2.4 (process analysis) - Manual (Page 1049)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1033
Designation Description
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is reached
.MI.MEA Minimum measured value (U
ind
) in mV
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.SLO Slope of the sensor used in the command
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
.TC.CO Coefficient c0 of the Chebyshev polynomial of the solu-
tion used
.TC.C1 Coefficient c1 of the Chebyshev polynomial of the solu-
tion used
.TC.C2 Coefficient c2 of the Chebyshev polynomial of the solu-
tion used
.TC.C3 Coefficient c3 of the Chebyshev polynomial of the solu-
tion used
.TC.C4 Coefficient c4 of the Chebyshev polynomial of the solu-
tion used
.TC.MAX Maximum temperature coefficient in %/°C (
.TC.MIN Minimum temperature coefficient in %/°C (
.TC.TSTART Start temperature in °C
.TC.TSTOP Stop temperature in °C
5.6.4.11.2 MEAS TC Cond - General/Hardware
Tab: Method ▶ MEAS TC Cond ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the device are defined on this tab.