Metrohm tiamo 2.4 (process analysis) - Manual (Page 774)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
758 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Manual start after sample addition with [Continue]
on | off (Default value: off)
If this option is activated, then the titration will be started manually after
the sample addition by pressing the [Continue] button in the message
window.
Only start titration by a start command from a SEND command
on | off (Default value: off)
If this option is activated, then the titration will not be started until the
Event message Start titration is sent to the command with a SEND
command.
NOTE
Conditioning must already be completed (= Condok) at the time the
SEND command is received, otherwise the command to start the
titration will be ignored.
Show measured value during conditioning
on | off (Default value: off)
If this option is enabled, then the measured value will be shown in the
subwindow Live display of the program part Workplace, in addition to
the drift and the time.
5.6.3.4.5.8 SET Ipol - Additional evaluations
Tab: Method ▶ SET Ipol ▶ Properties... ▶ Additional evaluations
Command name
Name of the command.
Entry 25 characters
The following additional methods for evaluation of titration curves can be
activated and defined on this tab:
Fixed endpoint evaluation
Fixed endpoint evaluation
on | off (Default value: off)
If this check box is activated, then the associated values for the other
measured quantities will be interpolated with a fixed measured quantity
(Measured value, Time or Volume) for the fixed endpoint from the
measuring point list.