Metrohm tiamo 2.4 (process analysis) - Manual (Page 1484)

6.10 Subwindow Global variables
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1468 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
6.10 Subwindow Global variables
6.10.1 Configuration - Global variables
Subwindow: Configuration ▶ Global variables
Subwindow Global variables
The subwindow Global variables contains the table with the configured
global variables. It can be shown in the program part Configuration as a
part of the Configuration view or (if not present on the desktop) in a sepa-
rate window with View
▶ Quick access. The subwindow can be
enlarged and reduced as required; it can also be maximized.
Using global variables
Global variables are method-embracing variables that are stored overall
clients and can be used in formulas under the designation 'GV.Name'.
They are either entered manually in the configuration or assigned in the
method run by a CALC command.
NOTE
For global variables which are newly calculated during a determination
in a CALC command and which are saved in the configuration, the cur-
rent values are available for additional calculations in the same determi-
nations from this instant. This is not the case for determinations running
at the same time on other workplaces; here, the values available at the
start of the determination are applied.
6.10.2 Table of global variables
6.10.2.1 Table of global variables
Subwindow: Configuration ▶ Global variables
Contents
The table of global variables shows the following information about the
global variables as standard:
Name
Name of global variable.
Type
Type of global variable (Number, Text or Date/Time).
Value
Value of the global variable.