Metrohm tiamo 2.4 (process analysis) - Manual (Page 1475)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1459
6.9 Subwindow Global variables
6.9.1 Configuration - Common variables
Subwindow: Configuration ▶ Common variables
Subwindow Global variables
The subwindow Common variables contains the table with the config-
ured common variables. It can be shown in a separate window in the pro-
gram part Configuration as a part of the Configuration view or (if not
present on the desktop) with View
▶ Quick access. The subwindow can
be enlarged and reduced as required; it can also be maximized.
Using common variables
Common variables are cross-method variables that are stored per client
and can be used in formulas under the designation 'CV.Name'. They are
either entered manually in the configuration or assigned in the method
run by a CALC command.
NOTE
For common variables which are newly calculated during a determina-
tion in a CALC command and which are saved in the configuration, the
current values are available for additional calculations in the same
determinations from this point in time. This is not the case for determi-
nations running at the same time on other workplaces; here, the values
available at the start of the determination are applied.
6.9.2 Table of common variables
6.9.2.1 Table of common variables
Subwindow: Configuration ▶ Common variables
Contents
The table of common variables shows the following information about the
common variables as standard:
Name
Name of common variable.
Type
Type of common variables (Number, Text or Date/Time).
Value
Value of common variables.